工程管理における工程と制御条件の最適化の方法　　プラスチック成形工程への適用

DOI Web Site

書誌事項

タイトル別名
  • Optimization method of production process and control parameters. Application to plastic injection molding process.
  • コウテイ カンリ ニ オケル コウテイ ト セイギョ ジョウケン ノ サイテキ
  • Application to Plastic Injection Molding Process
  • プラスチック成形工程への適用

この論文をさがす

説明

This paper presents an application of new statistical parameter optimization method to designing plastic injection molding process. Optimum condition is derived by combining highest level of SN ratio of each parameter. The SN ratio represents the variance of products and the process control ability in trial production on many parameter's conditions layouted orthogonal array. This optimization is carried out on two characteristics of products. Selection method of control parameters is discussed to reduce process fluctuation still remained after the parameter optimization. The effect of optimization and the possibility of control by the method are confirmed experimentally. The results show improvement in the process variance of more than 5 dB and possibility of both two-characteristics optimization and control.

収録刊行物

  • 精密工学会誌

    精密工学会誌 53 (10), 1602-1608, 1987

    公益社団法人 精密工学会

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ