エンドミルの溝削りにおける切削特性

DOI Web Site

書誌事項

タイトル別名
  • Cutting characteristics on slotting of endmill.
  • エンドミル ノ ミゾケズリ ニ オケル セッサク トクセイ

この論文をさがす

抄録

Cutting characteristics on slotting of endmill, that is the most complicated cutting method of milling, are examined experimentally. From the precise measurements of cutting resistance variation and surface roughness in one cutting cycle, it is clarified that table feed direction force does not change the direction at 90°of rotating angle of cutting edge which is the turning point between up-cut milling and down-cut milling, but changes the direction at about 120° of rotating angle of cutting edge and surface roughness changes into four stages in one cutting cycle. Moreover, it is clarified that transient up-cut milling region exists between 90° and about 120° of rotating angle of cutting edge.

収録刊行物

  • 精密工学会誌

    精密工学会誌 53 (10), 1555-1561, 1987

    公益社団法人 精密工学会

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ