油膜付水滴加工液を用いたエンドミル加工の加工精度

書誌事項

タイトル別名
  • Machining Accuracy in End-milling with Oil Film on Water Fog Metal Working Fluid
  • ユマク ツキ スイテキ カコウエキ オ モチイタ エンドミル カコウ ノ カコウ セイド

この論文をさがす

抄録

Recently, waste treatments in the traditional coolant system have been causing increase in manufacturing costs because of environmental concern. A new cutting fluid supply system (Oil film on Water fog: OoW) has been proposed for an environmental measure. The new system supplies the comparatively large water particles covered with very thin vegetable oil to a machining point with air jet. In this paper, milling tests, shaping two cylindrical bosses from an aluminum alloy block, are carried out, and the machining accuracy is examined for the practical use of this system. The experimental results are compared with the results used conventional coolant and minimal quantity of lubricant (MQL). As OoW has an enough cooling ability, the accuracy of products with OoW is finer than that with MQL, and is as same as that with conventional coolant. Consequently, it is concluded that the new system is expectable as one of the ecological-friendly machining methods.

収録刊行物

  • 精密工学会誌

    精密工学会誌 69 (9), 1342-1347, 2003

    公益社団法人 精密工学会

被引用文献 (9)*注記

もっと見る

参考文献 (9)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ