Slit width Measurement of a Long Precision Slot Die
-
- FURUKAWA Masaru
- 東北大学大学院
-
- GAO Wei
- 東北大学大学院工学研究科
-
- SHIMIZU Hiroki
- 東北大学大学院工学研究科
-
- KIYONO Satoshi
- 東北大学大学院工学研究科
-
- YASUTAKE Mutsumi
- (株)リョウテック
-
- TAKAHASHI Kazuhiko
- (株)リョウテック
Bibliographic Information
- Other Title
-
- 高精度長尺塗布工具のスリット幅測定に関する研究
- コウセイド チョウシャク トフ コウグ ノ スリットハバ ソクテイ ニ カンスル ケンキュウ
Search this article
Abstract
This paper presents a CCD camera-based system for slit width measurement of long precision slot dies. The slit width is calculated from the binary image of the slit after positions of the two edges of the slit are determined through a least square linear fitting of the edge data. The resolution of the CCD camera is on the order of sub-microns, which satisfies the requirement of quality control of the slit width. Local slit width can also be obtained because of the small field of view of the CCD camera. The slit width over the entire slot die can be measured enough scanning the CCD camera. The influence of the Z-directional straightness of the scanning stage can be reduced by choosing a proper threshold for binarization of the CCD image. Experimental results have shown that the slit width over the entire length of a 1.4 m long slot die can be measured in 33 seconds.
Journal
-
- Journal of the Japan Society for Precision Engineering
-
Journal of the Japan Society for Precision Engineering 69 (7), 1013-1017, 2003
The Japan Society for Precision Engineering
- Tweet
Details 詳細情報について
-
- CRID
- 1390001204797440256
-
- NII Article ID
- 110001368507
-
- NII Book ID
- AN1003250X
-
- ISSN
- 1882675X
- 09120289
-
- NDL BIB ID
- 6638695
-
- Text Lang
- ja
-
- Data Source
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- Abstract License Flag
- Disallowed