High Speed and High Accuracy Machining of Long Flexible Parts with Combined Face Milling Cutters
-
- ONOZUKA Hideaki
- (株)日立製作所 生産技術研究所
-
- KAZAMA Shigeru
- (株)日立製作所 都市開発システム社
-
- OOTSUKI Hiroyuki
- (株)日立製作所 都市開発システム社
-
- KOIZUMI Yukihisa
- (株)日立製作所 都市開発システム社
-
- UENO Keii
- (株)日立製作所 生産技術研究所
-
- MAEDA Yukio
- 富山県立大学 工学部知能デザイン工学科
-
- OBIKAWA Toshiyuki
- 東京大学 生産技術研究所
Bibliographic Information
- Other Title
-
- 複合フライスによる長尺部材の高速・高精度加工の研究
- フクゴウ フライス ニ ヨル チョウシャク ブザイ ノ コウソク コウセイド カコウ ノ ケンキュウ
Search this article
Abstract
This paper describes an innovative method to machine the guide rails for elevators in high efficiency and high accuracy. Guide rails are usually machined on a planer. However, the machining time is long because of the useless return motion of the table and low cutting speeds. In order to decrease the machining time, face milling with combined cutters was applied to the machining of guide faces. The trial face milling of guide rails indicated the reduction of the width of guide rails at the tool exit and deterioration of the perpendicularity of guide faces. Thus, in this research, the machining mechanism affecting the accuracy of the machined surfaces was studied. The analytical and experimental results revealed that cutter path deviation from the center of a guide rail affects the width reduction at the exit part of the guide rail, whilst the clamping stiffness of the guide rail has a much greater influence on the perpendicularity of the guide face than the cutter path deviation. It was also found that change in the number of cutting edges engaged in machining simultaneously caused wavy machined surface with a long wave length. Finally, determined based on the above findings were the critical tool path deviation and critical clamping stiffness, which permitted the efficient machining of the guide rails at a high cutting speed of 267m/min and a high feed rate of more than 1000mm/min, decreasing machining time by a factor of six.
Journal
-
- Journal of the Japan Society for Precision Engineering
-
Journal of the Japan Society for Precision Engineering 76 (7), 769-774, 2010
The Japan Society for Precision Engineering
- Tweet
Details 詳細情報について
-
- CRID
- 1390001204797581184
-
- NII Article ID
- 130000421867
-
- NII Book ID
- AN1003250X
-
- ISSN
- 1882675X
- 09120289
-
- NDL BIB ID
- 10768706
-
- Data Source
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- Abstract License Flag
- Disallowed