High Spindle Speed Micro EDM Using Electrostatic Induction Feeding Method
-
- YAHAGI Yuna
- 東京農工大学
-
- KOYANO Tomohiro
- 東京大学
-
- KUNIEDA Masanori
- 東京大学
-
- YANG Xiaodong
- ハルビン工業大学
Bibliographic Information
- Other Title
-
- 静電誘導給電による高速回転電極を用いた微細放電加工
- セイデンユウドウ キュウデン ニ ヨル コウソク カイテン デンキョク オ モチイタ ビサイ ホウデン カコウ
Search this article
Abstract
This paper describes machining characteristics of high spindle speed micro electrical discharge machining (EDM) using the electrostatic induction feeding method. In this method, non-contact electric feeding allows the tool electrode to be rotated at high speed up to fifty thousand rpm. In micro EDM, it is considered that higher spindle speed is more useful in flushing debris particles from the gap and cooling the tool electrode. In addition, since the heat spot generated by each discharge is separated by a sufficiently long distance on the periphery of the rotating tool electrode due to the relative motion between electrodes, the locally elevated temperature can be lowered. Thus an experimental setup for high spindle speed micro EDM using the electrostatic induction feeding method was newly developed. Machining results showed that machining speed and surface roughness can be improved, and that tool wear rate can be lowered. In micro drilling, deeper micro-holes, smaller gaps and better straightness were obtained due to the high flushing efficiency at the high spindle speed.
Journal
-
- Journal of the Japan Society for Precision Engineering
-
Journal of the Japan Society for Precision Engineering 77 (4), 394-399, 2011
The Japan Society for Precision Engineering
- Tweet
Details 詳細情報について
-
- CRID
- 1390001204797590400
-
- NII Article ID
- 130001155794
-
- NII Book ID
- AN1003250X
-
- ISSN
- 1882675X
- 09120289
-
- NDL BIB ID
- 11081814
-
- Text Lang
- ja
-
- Data Source
-
- JaLC
- NDL
- Crossref
- CiNii Articles
- KAKEN
-
- Abstract License Flag
- Disallowed