書誌事項
- タイトル別名
-
- High Speed Cutting of Super Heat Resisting Alloy Inconel 718. On the Finish Cutting with High Pressurized Cutting Fluid.
- チョウタイネツ ゴウキン インコネル 718 ノ コウソク セッサク カコウ コウアツ チュウエキ オ モチイタ シアゲ セッサク
- On the Finish Cutting with High Pressurized Cutting Fluid
- 高圧注液を用いた仕上げ切削
この論文をさがす
説明
The super heat resisting alloy Inconel 718 used in gas turbines is known as difficult-to-machine materials. Under the same cutting conditions, the tool wear progresses at a noticeably quicker pace than that in cutting metals such as carbon steel. At the present time, the cutting speed is reduced during machining Inconel 718. There is an increasing demand for more efficient cutting in this field. Accordingly, a high speed cutting was attempted at increased cutting fluid flow rate by injecting fluid at a high pressure to the cutting edge. As a result, as the injection speed of the cutting fluid went up, the cutting temperature was reduced and the flank wear was reduced. And these experiments showed the prospective result that the cutting speed could be increased with high pressurized cutting fluid (high pressure injection). In the next step, cutting of Inconel 718 was attempted by using a rotary tool under the high pressure injection. Furthermore, the flank wear was reduced and the tool life could be improved.
収録刊行物
-
- 精密工学会誌
-
精密工学会誌 66 (10), 1611-1615, 2000
公益社団法人 精密工学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390001204797933696
-
- NII論文ID
- 110001372791
-
- NII書誌ID
- AN1003250X
-
- ISSN
- 1882675X
- 09120289
- http://id.crossref.org/issn/09120289
-
- NDL書誌ID
- 5502412
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDLサーチ
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可
