絶縁性AlNセラミックスの微細放電加工特性

DOI Web Site 参考文献1件

書誌事項

タイトル別名
  • Machining Characteristics of Insulating AlN Ceramics by Micro EDM
  • ゼツエンセイ AlN セラミックス ノ ビサイ ホウデン カコウ トクセイ

この論文をさがす

抄録

As a sintered AlN ceramics material have the superior thermal conductivity and high electrical insulation properties. However, AlN is too brittle to machine for the precise and micro product by mechanical machining method, the application field is restricted. On the other hand, many insulating ceramic materials could be machined precisely by EDM with the assisting electrode method. As reported before, the removal rate of high thermal conductivity material such as AlN, SiC, and diamond is lower than other insulating materials. In this research, to obtain the better machining properties on the sintered AlN ceramics, effects of tool electrode polarity and working fluid in RC discharge circuit were investigated on the electrical discharge machining characteristics. As a result, the higher removal rate and the larger electrode wear ratio were shown in the tool electrode polarity of positive. Moreover, aluminum element was observed as the component element of electrical conductive layer on the machined surface. Using the decomposed aluminum layer as the electrical conductive layer, an AlN could be EDMed in demineralized water instead of working oil. The removal rate and tool electrode wear ratio in deionized water was three times higher and three times lower respectively than that of working oil.

収録刊行物

  • 精密工学会誌

    精密工学会誌 79 (6), 540-546, 2013

    公益社団法人 精密工学会

参考文献 (1)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ