微細エンドミル加工における加工状態のモニタリング

DOI

書誌事項

タイトル別名
  • Cutting Condition Monitoring in Milling Operation with Micro End mill

抄録

In the case of milling with micro end mill, cutting force, cutting sound and vibration are too small to detect tool breakage or abnormal cutting conditions. These were reasons why suitable measuring tool was not supplied until now. In previous papers, we have proposed a equipment to measure small cutting force acting on micro end mill in x-y plane. Deflection of a tool was captured by CCD camera and processed to measure cutting force.<br>In this paper, our proposed equipment was applied to milling process with micro end mill to optimize cutting process and detect abnormal cutting condition. In optimization, relation between cutting force and cutting volume was formulated and optimization effect was verified by the proposed equipment. In detection of abnormal cutting condition, relation between tool wear and RMS value of cutting force was estimated.<br>Finally, we optimized cutting condition and detected abnormal cutting condition very well.

収録刊行物

  • 精密工学会誌

    精密工学会誌 80 (11), 1031-1035, 2014

    公益社団法人 精密工学会

詳細情報

  • CRID
    1390001204829948416
  • NII論文ID
    130004706152
  • DOI
    10.2493/jjspe.80.1031
  • ISSN
    1882675X
    09120289
  • 本文言語コード
    ja
  • データソース種別
    • JaLC
    • Crossref
    • CiNii Articles
  • 抄録ライセンスフラグ
    使用不可

問題の指摘

ページトップへ