低炭素アルミニウムキルド鋼板の過時効過程の電気抵抗-熱電能測定による検討

DOI Web Site Web Site 参考文献3件

書誌事項

タイトル別名
  • Study of Over-ageing Process of Al-killed Low Carbon Steel Sheet by Measurements of Electrical Resistivity and Thermoelectric Power
  • テイ タンソ アルミニウム キルド コウハン ノ カジコウ カテイ ノ デンキ

この論文をさがす

抄録

The following points are studied using Al-killed low carbon steel sheet for two ageing processes ; ageingafter quenching from 650-700°C to 0°C and reheating to 300-450°C (Q.A. process), and ageing after direct quenching from these annealing to ageing temperatures (D.A. process). The slope of thermoelectric power versus electrical conductivity plot is determined to be 295±5 μVK -1μ Ω cm, irrespectively of the processes. Residual solute carbon concentration after Q.A. is reconfirmed to be a little less than that after D.A.. Dependence of precipitation kinetics on grain sizes and quenched-in supersaturation of carbon is found to be different between the two processes, when the annealing temperature is low and the ageing temperature is high. A calculation based on a model of diffusion of carbon shows that the differences correspond to observed different distribution densities of carbides particles. The result indicates promotion of carbide nucleation by the reheating stage of the Q.A. process. Time to attain an equilibrium partition of carbon atoms to Mn-C dipole sites and to interstitial sites free from manganese atoms is estimated to discuss measured relative concentrations of carbon in the two sites. The estimation demonstrates difficulty of quenching for the equilibrium partition.

収録刊行物

  • 鉄と鋼

    鉄と鋼 74 (1), 159-166, 1988

    一般社団法人 日本鉄鋼協会

参考文献 (3)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ