書誌事項
- タイトル別名
-
- Machinability of Nodular Cast Irons : Part I, Tool Forces and Flank Adhesion
- ノジュラー チュウテツ ノ ヒサクセイ 1
この論文をさがす
抄録
Three grades of nodular cast iron (60, 80, and 100) were tested to determine the cutting force and net horsepower required to machine the materials, to determine the performance of several grades of carbide and ceramic cutting tools, and to investigate the flank adhesion phenomenon. Cutting force required to machine 80 and 100 grades decreased smoothly with an increase in cutting speed. It was found that the effect of feed rate on cutting force was larger than that of depth of cut. When grade 60 was machined with carbide tools, flank adhesion was encountered with accompanying sharp increases in cutting force values at speeds above a critical cutting speed. This critical cutting speed and the increase in cutting force decreased as the titanium content of the cutting tool increased. No flank build-up occurred with ceramic tools. This phenomenon was explained by the oxide film theory.
収録刊行物
-
- 日本機械学會論文集
-
日本機械学會論文集 27 (184), 1909-1921, 1961
一般社団法人 日本機械学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001205155286144
-
- NII論文ID
- 110002351553
-
- NII書誌ID
- AN00187419
-
- ISSN
- 21859485
- 00290270
-
- NDL書誌ID
- 9150891
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可