書誌事項
- タイトル別名
-
- The Effects of Runner Surface Roughness on the Performance of a Francis Turbine
- フランシス スイシャ ハネグルマ リュウロ ノ ヒョウメンア ラ サ ノ スイシャ セイノウ ニ オヨボス エイキョウ
この論文をさがす
抄録
The effects of runner surface roughness on the performance of a Francis turbine have been studied experimentally. The performance data were obtained for seven various type roughnesses k from 0.007 to 1.0 mm. Preliminarily, the frictional resistance of enclosed rotating disks with the respective roughness was measured for laminar and turbulent flows, in order to relate these different roughnesses to hydraulic frictional resistance. By these disk-friction tests, roughnesses of these surfaces could be expressed by the equivalent Nikuradse sand-grain diameter (equivalent sand roughness). The following conclusions may be drawn from this experimental study. (1) The turbine efficiency diseases in proportion to the frictional resistance of its equivalent sand roughness. (2) With increasing roughness, the maximum efficiency point shifts to the lower steed and the lower flow rate. (3) Concerning the admissible roughness, Schlichiting formula is in good agreement with this experiment.
収録刊行物
-
- 日本機械学會論文集
-
日本機械学會論文集 29 (204), 1284-1293, 1963
一般社団法人 日本機械学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001205157852416
-
- NII論文ID
- 110002462028
- 110002351897
-
- NII書誌ID
- AN00187419
-
- ISSN
- 21859485
- 24242675
- 00290270
-
- NDL書誌ID
- 9151217
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可