書誌事項
- タイトル別名
-
- A Study of Hot Machining : Orthogonal Cutting Mechanism at High Temperature
- コウオン セッサク ニ カンスル ケンキュウ
この論文をさがす
抄録
This paper describes the mechanism of orthogonal cutting at high temperature employing mainly the analysis of mechanism with the transitional deformation range and experimental data for lead, brass, carbon steel and stainless steel. From the experimental results, it was revealed that the sector angle of flow region and inclination of ending boundary line increased with work temperature, and the tendency of the orthogonal cutting mechanism at high temperature was similar to that of increasing rake angle of the tool. In consequence, it was found that the machinability based upon the chip formation at high temperature was better than that at room temperature.
収録刊行物
-
- 日本機械学會論文集
-
日本機械学會論文集 30 (217), 1019-1026, 1964
一般社団法人 日本機械学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001205158945792
-
- NII論文ID
- 110002352099
-
- NII書誌ID
- AN00187419
-
- ISSN
- 21859485
- 00290270
-
- NDL書誌ID
- 9151410
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可