書誌事項
- タイトル別名
-
- On the Machining of the Polygonal Profile
- ポリゴン ダンメン ノ コウサク ニ ツイテ ダンメン ケイジョウ ノ ソクテイホウ オヨビ ソクテイ セッショクキュウ ノ マルミ ガ ケイジョウ ゴサ ノ ソクテイ ニ オヨボス エイキョウ 4
この論文をさがす
抄録
Polygonal profiles used for couplings must be precise in shape. Therefore, the following conditions must be satisfied in the measurement of this kind of profile : a. The rotation angle must be precise in the range 0°∼360° ; b. The radius must be equally correct ; c. The same degree of precision is desirable for the measurement of the shaft and the boss. Taking into consideration of the above conditions, the author adopted the feeler method apparatus on the toolmakers' microscope. In this measurement, the roundness of the measuring edge has an effect upon the accuracy of the profile measurent. In this report, the author studied the theoretical values of error in reading of the lathe-turned profile and the ground profile. And based on the correction formula, the correction chart of profile measurement was prepared for the practical use. According to this chart, the results of the close examination for the experimental polygonal shafts were indicated.
収録刊行物
-
- 日本機械学會論文集
-
日本機械学會論文集 30 (220), 1476-1485, 1964
一般社団法人 日本機械学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001205158953088
-
- NII論文ID
- 110002352154
-
- NII書誌ID
- AN00187419
-
- ISSN
- 21859485
- 00290270
-
- NDL書誌ID
- 8366500
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可