書誌事項
- タイトル別名
-
- Reaming on 18-8 Stainless Steel : Concerning the Surface Roughness and the Accuracy
- 18-8 ステンレス コウ ノ リーマ カコウ
この論文をさがす
説明
This paper describes the conditions to get good surface roughness and the accuracy of reamed hole on 18-8 stainless steel. As the built-up edge affects much the finish and existence of built-up edge on 18-8 stainless steel was not clear, existence was investigated at low cutting speed before the experiment of reaming, and the built-up edge was recognized at such a low cutting speed on 18-8 stainless steel. So, it is neccessary for good finish to prevent the growth of built-up edge as small as possible at reaming on 18-8 stainless steel. For this purpose sulphurized oil is effective as the cutting fluid. Concerning reaming conditions, proper reamer angles, reamer dimensions, cutting speeds and feed speeds can be obtained.
収録刊行物
-
- 日本機械学會論文集
-
日本機械学會論文集 30 (220), 1441-1449, 1964
一般社団法人 日本機械学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001205158954624
-
- NII論文ID
- 110002352150
-
- NII書誌ID
- AN00187419
-
- ISSN
- 21859485
- 00290270
-
- NDL書誌ID
- 8366504
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可