書誌事項
- タイトル別名
-
- Drilling on 18-8 Staioless Steel : Concerning with the Surface Roughness and the Accuracy
- 18-8 ステンレス コウ ノ ドリル カコウ
この論文をさがす
抄録
This paper describes the surface roughness and the accuracy of drilled hole on 18-8 stainless steel. I refered to my report "Adhesions between Various Tool Materials and 18-8 Stainless steel". The results are as follows : To prevent the adhesions between the stainless steel and the drill is most effective for good finish. For this purpose, Su1phurized Oil is effective as the cutting fluid. Concerning the drilling conditions, proper cutting edge angles, cutting speeds and feed speeds can be obtained. Low temperature drilling is effective, too, for slow feed.
収録刊行物
-
- 日本機械学會論文集
-
日本機械学會論文集 29 (202), 1043-1053, 1963
一般社団法人 日本機械学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001205159243008
-
- NII論文ID
- 110002351867
-
- NII書誌ID
- AN00187419
-
- ISSN
- 21859485
- 00290270
-
- NDL書誌ID
- 9151183
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可