書誌事項
- タイトル別名
-
- X-Ray Investigation of Stress Measurement : On the Method of Measurement, the Effect of the Radiation Area and Resolving Power
- Xセン ニ ヨル オウリョク ソクテイホウ ニ カンスル ケンキュウ
この論文をさがす
抄録
Several basic problems concerning the stress measurement by X-ray remain to be further investigated for example, the correspondence of the stress measured by X-ray method to that obtained by mechanical means. The authors had found out the practical significance of appling sin2 ψ method (Christenson and Rowland method) to stress measuring, and examined of the effect of radiation area on the stress value using both the film and counter method in plate specimens of 0.07% and 0.55% carbon steels. 1) Stresses measured by the film showed sufficiently exact values under the test condition employed by the authors. Measured stresses were in fairly good agreement with the mechanically obtained ones. 2) In the case of counter method applied to the heat-treated specimens of carbon steel, the value of cosec θψ was found to be deviated from the theoretical one for the oblique incidence of 45° owing to the absorption of X-ray by materials, and asymmetricity of diffracted X-rays. This tendency becoms more conspicuous as the radiation area is increased. Therefore, sin2ψ method should be used in this case.
収録刊行物
-
- 日本機械学會論文集
-
日本機械学會論文集 29 (200), 645-657, 1963
一般社団法人 日本機械学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001205159324928
-
- NII論文ID
- 110002351819
-
- NII書誌ID
- AN00187419
-
- ISSN
- 21859485
- 00290270
-
- NDL書誌ID
- 9151143
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可