A286合金溶接材の4Kおよび300Kにおける機械的性質と低サイクル疲労強度

DOI Web Site Web Site 参考文献2件

書誌事項

タイトル別名
  • Mechanical Properties and Low Cycle Fatigue Strength at 4 and 300 K of Welded Alloy A286
  • A286 ゴウキン ヨウセツザイ ノ 4K オヨビ 300K ニ オケル キカ

この論文をさがす

抄録

The tensile, Charpy impact and fatigue properties of TIG welded alloy A286 have been investigated at 4 and 300 K. The base material was forged plates of 35 mm thick of electroslag remelted A286 in which the composition of minor elements such as C, Si and B was tightly controlled. The plates were welded by using A286 filler metal without fusion zone hot cracking and HAZ fissuring except for a small amount of micro-defects dispersed in the weld metal. The yield and tensile strengths, ductility and fatigue strength of the weldment were lower than those of the base material owing to strain localization at the softened weld metal zone. The post-weld heat-treatment which consists of homogenization followed by aging restored the lowered strengths, ductility and the fatigue strength of notched specimen near to those of the base material. The absorbed energy at 4 K of the base material, weldment and heat-treated weldment was almost the same, about 60 J. Though the micro-defects in the weld metal slightly decreased the ductility and absorbed energy, they did not cause any harmful effects on the yield and tensile strengths of the weldment and heattreated weldment. The fatigue strength of smooth specimens after the post-weld heat-treatment was, however, sensitive to the size or the number of the micro-defects and the S-N data were dispersed among those for the smooth specimens of the base material at 4 and 300 K.

収録刊行物

  • 鉄と鋼

    鉄と鋼 73 (14), 1770-1777, 1987

    一般社団法人 日本鉄鋼協会

参考文献 (2)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ