Simulation of Particle Motion in a Jig Separator

  • ASAKURA K.
    Graduate School of Engineering, Hokkaido University, Sapporo 060-8628, Japan
  • NAGAO M.
    Graduate School of Engineering, Hokkaido University, Sapporo 060-8628, Japan
  • MIZUNO M.
    National Institute of Advanced Industrial Science and Technology, Sapporo 062-8517, Japan

この論文をさがす

抄録

The motion of particles in fluid flow in a jig separator was investigated numerically and three-dimensional flow in the jig was calculated by the SIMPLE algorithm. The motion of particles was expressed by the BBO-type equation. The contact forces among particles were calculated by a discrete element method (DEM) extended to particles with size distributions. The results of simulation showed that two types of spherical particles with a difference in density of 10 kg/m3 but the same diameters could be classified (separated). In addition, particles with the same settling velocities and different diameters could also be classified (separated). To analyze the motion of particles in the jig, we derived an equation for the response time of the particle that included added mass, gravity, and drag forces.

収録刊行物

  • 実験力学

    実験力学 7 (Special_Issue), s21-s26, 2007

    日本実験力学会

参考文献 (9)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ