書誌事項
- タイトル別名
-
- A Simple Measuring Method of Welding Inherent Deformation Using Inverse Analysis
- ギャクカイセキ ニ ヨル ヨウセツ コユウ ヘンケイ ノ ケイソクホウ ニ カンスル ケンキュウ
この論文をさがす
説明
During welding, deformation is produced as an unavoidable consequence. Inherent deformation method, in which the inherent deformation is introduced into the elastic FEM as the initial strain is one of the effective methods to predict welding deformation of large structures. When the weld length is long enough, inherent deformation is mainly governed by the heat input Q and the thickness of plate t. However, in assembling process of thin plates, the short weld with the length between 20〜200mm is often used especially to reduce distortion. In this case, inherent deformation is influenced not only by the heat input but also by the length of weld. In this research, an efficient measuring method to estimate inherent deformation of plate under bead welding using inverse analysis is developed. Based on this inverse analysis, the inherent deformation is estimated by measuring the three-dimensional coordinates at small number of selected points. Further, using the estimated inherent deformation, the welding deformation of a plate is predicted as the forward analysis. The distribution characteristic of the inherent deformation in short weld is also discussed in this paper.
収録刊行物
-
- 関西造船協会論文集
-
関西造船協会論文集 2004 (242), 89-96, 2004
社団法人 日本船舶海洋工学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001205199718016
-
- NII論文ID
- 110003880246
- 10014565702
-
- NII書誌ID
- AA11546894
-
- NDL書誌ID
- 7164063
-
- ISSN
- 13467727
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDLサーチ
- CiNii Articles
- KAKEN
-
- 抄録ライセンスフラグ
- 使用不可