マイクロ波の照射方法の違いがチタン酸バリウムの液相焼結に及ぼす影響について

DOI Web Site Web Site 被引用文献3件 参考文献6件
  • 安岡 正喜
    産業技術総合研究所 先進製造プロセス研究部門
  • 白井 孝
    産業技術総合研究所 先進製造プロセス研究部門
  • 西村 ゆつき
    産業技術総合研究所 先進製造プロセス研究部門
  • 杵鞭 義明
    産業技術総合研究所 先進製造プロセス研究部門
  • 渡利 広司
    産業技術総合研究所 先進製造プロセス研究部門

書誌事項

タイトル別名
  • Influence of Microwave Irradiation Method on the Sintering of Barium Titanate with Liquid Phase

この論文をさがす

説明

The ceramic industry uses enormous amounts of energy to make products at high temperatures. Therefore energy-saving measures based on sintering process improvements are being examined. Barium titanate in the presence of a liquid phase was irradiated by two different methods during microwave sintering: an intermittent use of the same high power levels (time-control method) and a continuous use of lower, increasing levels of power (power-control method). As a result, it is concluded that the liquid phase is generated faster in the time-control method provided that the microwave irradiation is carried out at a temperature which is higher than the generation temperature of liquid phase. The liquid phase was generated at a wider temperature in the power-control method. It has been understood that the temperature control becomes difficult, though the time-control method is more efficient for energy efficiency.<br>

収録刊行物

被引用文献 (3)*注記

もっと見る

参考文献 (6)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ