セラミックス顆粒の圧縮変形特性がCIP成形性及び焼結性に及ぼす影響 (第3報)

DOI Web Site Web Site 被引用文献3件 参考文献11件 オープンアクセス

書誌事項

タイトル別名
  • The Effect of Characteristics of Compressive Deformation of Ceramic Granules on CIP Compaction Behavior and Sinterability (Part 3)
  • セラミックス カリュウ ノ アッシュク ヘンケイ トクセイ ガ CIP セイケ
  • Relationship between CIP Compaction Method and Density Distribution in Compact
  • CIP成形方法と成形体中の密度分布との関係

この論文をさがす

説明

Vickers hardness distributions in disk shaped and hollow-disk shaped compacts with SiC granules, which showed typical elasto-plastic behavior, and their sintering shrinkage were measured to investigate the influence of the CIP Compaction method on the density distribution. The reduction of raw density toward the center in the radial direction was indicated indirectly from Vickers hardness measurements for the disk shaped compact. For the hollow-disk shaped compact prepared with mandrel, however, the density near the interface to mandrel increased extremely, while little or no density gradient was observed in other part. In the hollow-disk shaped compact, the result that the shrinkage of inner diameter was smaller than that of outer diameter was qualitatively compatible with the density distribution provided by hardness measurements. The density distribution in the disk shaped compact from hardness measurements qualitatively agreed with the density distribution predicted by finite element method (FEM) analysis with assumption of nonlinearity for the powder material, but the density distribution in the hollow-disk shaped compact did not completely agree with that predicted by FEM. For the hollow-disk shaped compact, it was thought that the differences in results between measurements and FEM analysis were influenced by the reduction of applied pressure near the center and the stress concentration near the interface to mandrel.

収録刊行物

被引用文献 (3)*注記

もっと見る

参考文献 (11)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ