書誌事項
- タイトル別名
-
- On the Monitoring of Cutting Forces in End Milling Processes (2nd Report)
- エンドミル カコウ ニ オケル セッサク テイコウ ノ スイテイホウ ダイ2ホウ コテイ サイクル ニ オケル セッサク テイコウ ヨソク モデル ノ ドウテイ ト ソレニ モトヅク オクリ ソクド セイギョ
- -An Application to the Identification of a Prediction Model of Cutting Forces within Canned Cycles and Feedrate Control-
- －固定サイクルにおける切削抵抗予測モデルの同定とそれに基づく送り速度制御－
この論文をさがす
説明
Control strategies of cutting forces in end milling process have been long studied as a methodology to autonomously optimize cutting conditions. In particular, a model-based feedforward control approach has been recognized as a simple, and yet practical way to regulate the cutting force. This paper proposes an identification scheme of a prediction model of cutting force, and a feedrate control scheme based on it. Model identification cycles are included within a canned milling cycle, where the cutting force is estimated from servo motor current and spindle motor current in order to identify the cutting force prediction model. By performing cutting force control in subsequent processes based on the identified model, it is experimentally validated that the machining efficiency is significantly improved, while avoiding an excessive tool load.
収録刊行物
-
- 精密工学会誌論文集
-
精密工学会誌論文集 72 (2), 224-228, 2006
公益社団法人 精密工学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001205280119296
-
- NII論文ID
- 110004028570
-
- NII書誌ID
- AA11966630
-
- ISSN
- 18818722
- 13488716
- 13488724
-
- NDL書誌ID
- 7826283
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
- KAKEN
-
- 抄録ライセンスフラグ
- 使用不可