Growth of Pr Oxide Films by Atomic Layer Deposition Using Pr(EtCp)3, and Their Electrical Properties

DOI Web Site 13 References
  • KONDO Hiroki
    Department of Crystalline Materials Science, Graduate School of Engineering, Nagoya University
  • SAKASHITA Mitsuo
    Department of Crystalline Materials Science, Graduate School of Engineering, Nagoya University
  • ZAIMA Shigeaki
    Department of Crystalline Materials Science, Graduate School of Engineering, Nagoya University

Bibliographic Information

Other Title
  • Ｐｒ（ＥｔＣｐ）３を用いた原子層成長法によるＰｒ酸化膜の作製とその電気的特性
  • Pr EtCp 3 オ モチイタ ゲンシソウ セイチョウホウ ニ ヨル Pr サンカ マク ノ サクセイ ト ソノ デンキテキ トクセイ

Search this article

Description

Growth properties and electrical properties of Pr oxide films by an atomic layer deposition (ALD) technique using Pr(EtCp)3 are discussed in this paper. Slef-limiting growth of Pr oxide films at a rate of 0.07 nm/cycle and a thickness variation of less than 2% on 3-in. Si wafers were obtained. Polycrystalline cubic Pr2O3 films were grown on Si(001) substrates, while epitaxial growth of the cubic Pr2O3 film was found on a Si(111) substrate. Relatively fine capacitance-voltage curves were obtained for the Al/ALD-Pr oxide/Si(001) capacitors. The interface state density between the 130°C-grown ALD-Pr oxide film and the Si(001) substrate is about 1×1011 cm−2 eV−1. The dielectric constant of the ALD-Pr oxide film grown at 250°C was determined to be about 18, assuming that the dielectric constant of the interlayer is similar to that of SiO2.<br>

Journal

References(13)*help

See more

Keywords

Details 詳細情報について

Report a problem

Back to top