書誌事項
- タイトル別名
-
- Study on Improvement of Accuracies of Hole Drilling Method for Measurement of Residual Stresses.
- ザンリュウ オウリョク ソクテイ ノ タメ ノ Hole Drillingホウ ノ セイド ノ カイリョウ ニ カンスル ケンキュウ
この論文をさがす
抄録
The hole drilling method is a well-established technique for measuring residual stresses in a wide range of materials. In this paper, in order to improve the measurement accuracies of hole drilling method, several numerical results are shown in two cases such that radial strains and tangential strains around the circular hole are detected, by consideration of strain variation in the finite region of each gage area. The results obtained are summarized as follows. (1) The measurement accuracies become higher by detection of tangential strains than radial one. (2) It is necessary to calculate the strain average in each gage area for residual stress measurement. (3) The analytical theory which considers the strain variation are proved to be valid by the experiment using steel specimens.
収録刊行物
-
- 材料
-
材料 49 (1), 106-110, 2000
公益社団法人 日本材料学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001205393150976
-
- NII論文ID
- 110002293893
-
- NII書誌ID
- AN00096175
-
- ISSN
- 18807488
- 05145163
-
- NDL書誌ID
- 4965576
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可