EFFECT OF FRICTION WELDING ON CHARACTERISTICS OF PURE TITANIUM/A5083 ALUMINUM ALLOY JOINT
-
- FUJI Akiyoshi
- Department of Mechanical Engineering, National Kitami Institute of Technology
-
- NORTH Thomas H.
- Department of Metallurgy and Materials Science, Toronto University
-
- KIMURA Masaaki
- Department of Mechanical Engineering, National Kitami Institute of Technology
-
- AMEYAMA Kei
- Department of Mechanical Engineering, Ritsumeikan University
書誌事項
- タイトル別名
-
- Report 1: Joint Mechanical Properties
この論文をさがす
説明
The influence of friction welding conditions on the mechanical-joint tensile and bend ductility -properties of as-welded dissimilar friction joints between pure titanium (Ti) and aluminum-magnesium alloy (A5083) base materials was investigated. The tensile strength increased when high friction pressure (≥200MPa) and high upsetting pressure (≥300MPa) were used during friction welding. Joint tensile strength also increased when friction time decreased, and the highest strength was obtained using the friction time of 0.5s. The higher joint strength was observed for the contacting surfaces polished using a buff than that prepared using No.240 emery paper.The use of high friction and upsetting pressure values and short friction times resulted in dissimilar joints which fractured in A5083 substrate during joint tensile testing. The joint bend ductility also increased when high friction pressures (≥200MPa) and a short friction time (0.5s) were employed during joining. It was concluded that the selection of joining parameters that promotes the formation of thin transition and intermetallic layers produces dissimilar joints with satisfactory mechanical properties.
収録刊行物
-
- 材料
-
材料 44 (504Appendix), 188-192, 1995
公益社団法人 日本材料学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390001205444441472
-
- NII論文ID
- 110002283729
- 110002283730
-
- NII書誌ID
- AA11046472
-
- ISSN
- 18807488
- 05145163
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- Crossref
- NDLデジコレ（旧NII-ELS）
- CiNii Articles
- OpenAIRE
-
- 抄録ライセンスフラグ
- 使用不可