現場接合に適した梁端ディテールと溶接工法の組合せに関する研究

書誌事項

タイトル別名
  • RESEARCH OF THE COMBINATION OF THE BEAM END DETAIL AND THE WELDING METHOD SUITABLE FOR ON-SITE JOINT
  • ゲンバ セツゴウ ニ テキシタ リョウタン ディテール ト ヨウセツ コウホウ ノ クミアワセ ニ カンスル ケンキュウ

この論文をさがす

抄録

It is suggested asymmetry detail which has the non-scallop (access hole) method for upper side and the reinforcement welding around toe of the scallops for lower side of the beam. The purpose is to develop the detail and joint method has easiness to product and high capacity of plastic deformation suitable for on-site. In addition, new developed backing-less method which is overhead welding and overlay using the special consumable was combined instead of the backing plate which is jointed to groove bottom of the end of beam flange. Full-size beam-to-column assemblies applied these methods had high capacity of plastic deformation. This improvement mechanism is regard as reduction stress concentrations and controls of these balances by shape of overlay metal formed by arc welding. As the leg length of reinforced weld become increase, strain ratio of outer against center become decrease in the groove weld width of the beam end.

収録刊行物

参考文献 (3)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ