Study of Deposition Machining Using Electrical Discharge with Reciprocating Rotation in Air Gap
-
- Hirao Atsutoshi
- Faculity of Education, Niigata University
-
- Tani Takayuki
- Department of Industrial Information, Tsukuba University of Technology
-
- Gotoh Hiromitsu
- Department of Industrial Information, Tsukuba University of Technology
-
- Aoshima Shoju
- Technocoat Co., Ltd.
-
- Mohri Naotake
- National Institution for Academic Degrees and University Evaluation
この論文をさがす
抄録
This paper describes surface modification and surface deposition using a high-peak current discharge in an air gap and describes the relation between capacitance, which determines the peak current, and the deposition rate. The process is controlled manually using a rotating tool. The discharge circuit is a resistor-capacitor (RC) circuit, and switching is executed by means of a thyristor. The deposition of nickel onto a steel surface was performed using a nickel-based alloy for the electrode. The electrode was controlled with reciprocating rotation. The influence of the capacitance of the capacitor and the diameter of the electrode on the deposition rate was investigated. Using the proposed method, excellent surface deposition was achieved.
収録刊行物
-
- International Journal of Electrical Machining
-
International Journal of Electrical Machining 21 (0), 1-6, 2016
一般社団法人 電気加工学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001205756462336
-
- NII論文ID
- 130005395673
-
- NII書誌ID
- AN10564586
-
- ISSN
- 21885117
- 13417908
-
- NDL書誌ID
- 027561499
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可