書誌事項
- タイトル別名
-
- Tooth Geometry Design of Cylindrical Skiving Cutter for Internal Gears
- (最適設計法への取組み)
- (An Attempt to Optimization)
説明
<p>Gear skiving was developed about 100 years ago for cutting internal gears at high productivity. However, significant problems have prevented skiving from being used widespread. But recent technologies made it to receive attentions. The present paper proposes an evaluation index for continual changing work of cutting edge for internal gear skiving. From the distribution of the proposed index, it was confirmed that work for cutting became large on trailing side of cutting edge at the end of cutting.Fu rthermore, the work for cutting at topland of cutter account for large part of all. Finally, the work for cutting with cutting edges change periodically and the tooth flank of internal gear after cutting could be undulation because of the vibration of the work for cutting. </p>
収録刊行物
-
- 機素潤滑設計部門講演会講演論文集
-
機素潤滑設計部門講演会講演論文集 2016.16 (0), B4-1-, 2016
一般社団法人 日本機械学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001205890742272
-
- NII論文ID
- 130007152412
-
- ISSN
- 24243051
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可