A011 Pulsed Laser Milling Integrated Die and Mold Machining : Experimental Analysis of Laser Irradiation Method on Process Performance
-
- OGAWA Keiji
- The University of Shiga Prefecture
-
- NAKAGAWA Heisaburo
- The University of Shiga Prefecture
-
- NAKABOU Tatsurou
- The University of Shiga Prefecture
説明
This paper proposes a novel process to achieve high efficiency die and mold machining technology. The process consists of laser milling for rough process and micro end milling for finishing. In the present paper, reasonable pulsed laser irradiation method is investigated in advance. Some fundamental experiments were carried out to clarify influences of laser irradiation conditions on surface quality and material removal rate in case of hardened die steels for workpiece material. As a result, reasonable laser irradiation conditions including shorter pulse duration and higher peak power irradiation were derived.
収録刊行物
-
- Proceedings of International Conference on Leading Edge Manufacturing in 21st century : LEM21
-
Proceedings of International Conference on Leading Edge Manufacturing in 21st century : LEM21 2013.7 (0), 51-54, 2013
一般社団法人 日本機械学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001205899018112
-
- NII論文ID
- 110009973366
-
- ISSN
- 24243086
-
- 本文言語コード
- en
-
- データソース種別
-
- JaLC
- Crossref
- CiNii Articles
- OpenAIRE
-
- 抄録ライセンスフラグ
- 使用不可