-
- 矢沢 重彦
- 機械試験所
書誌事項
- タイトル別名
-
- On the Plastic Deformation of Tubes at the Exit of Sinking Dies
- ヒキヌキ ダイス デグチ ニ オケル カン ノ ヘンケイ ニ ツイテ
この論文をさがす
抄録
The difference between diameters of die-hole and of sunk tube is due to a plastic deformation of the tube which occurs after it has left completely the wall of dies. This plastic deformation is analysed theoretically under several assumptions. As a result, the difference between the diameters can be computed by using the values determined by sinking conditions and the mechanical properties of the sunk tube materials. The fillet radius of dies has a conspicuous influence on the plastic deformation of tubes and the ratio of the radius to the thickness of tubes should be larger than 10 to keep the difference between the diameters least. Experiments are carried out on steel tubes. The results agree well with the analysis.
収録刊行物
-
- 日本機械学会誌
-
日本機械学会誌 62 (484), 791-, 1959
一般社団法人 日本機械学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001205914245504
-
- NII論文ID
- 110002350968
- 110002456782
-
- NII書誌ID
- AN00187419
-
- ISSN
- 24242675
- 21859485
- 00290270
-
- NDL書誌ID
- 9150379
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可