レーザ・放電複合加工法による微細穴高速加工の研究―燃料噴射ノズルへの適用―

DOI Web Site 参考文献14件

書誌事項

タイトル別名
  • Study of High-Speed Microhole Drilling by Combined Process using Laser and EDM-Apply for fuel injection nozzle-
  • レーザ ホウデン フクゴウ カコウホウ ニ ヨル ビサイ ケツ コウソク カコウ ノ ケンキュウ ネンリョウ フンシャ ノズル エ ノ テキヨウ
  • - Apply for fuel injection nozzle -
  • ― 燃料噴射ノズルへの適用 ―

この論文をさがす

抄録

In the automobile industry, increasing the demands for better environment protection and resource conservation entails for lowering both fuel cost and exhaust emission. This is because combustor efficiency is markedly influenced by grain size, spray pattern, and the injection volume of fuel atomization. Therefore, to increase combustor efficiency it is effective to improve the size, pattern, and accuracy of nozzle holes. In mass production, conventional processing methods for nozzle holes include stamping and drilling. Noncontact processes such as electric discharge machining (EDM) has the advantages of smaller size, better pattern flexibility and better accuracy, however, they are not suitable for mass production. In this study, we introduced a new EDM method with both good accuracy and good productivity that are suitable for the finish machining of microholes having a diameter less than 0.2 mm. We found that for finish boring by EDM, the smaller the depth of cut, the lower the processing efficiency. Thus, to solve this problem, we suggested a new method that entails overlaying high frequency vibration to the electrode, and verified the effectiveness of the method by experiments. We verified the effective use of a high-frequency electrode feeding device together with the direct drive method for improving the processing efficiency. The finish EDM developed method is now in practical use in the mass production of fuel injection nozzle holes, which start as preholes made using a YAG laser.

収録刊行物

  • 電気加工学会誌

    電気加工学会誌 44 (106), 45-51, 2010

    一般社団法人 電気加工学会

参考文献 (14)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ