-
- 近藤 幹夫
- (株)豊田中央研究所
書誌事項
- タイトル別名
-
- Development of High Accuracy, High Density Powder Compaction Technology
- 受賞記念講演:平成17年度技術功績賞 高精度・高密度粉末成形技術の開発
- ジュショウ キネン コウエン ヘイセイ 17ネンド ギジュツ コウセキショウ コウセイド コウミツド フンマツ セイケイ ギジュツ ノ カイハツ
この論文をさがす
抄録
A lot of PM parts with complex and thin-walled shape have been used in automobile. Therefore, the PM parts were required to have high density and high strength. Both uniform powder filling method and high pressure powder compaction method are essential for fabrication of the PM parts with the high dimensional tolerance and high strength at low cost. At first, in order to improve the flowability of powders in a feed shoe, an aeration powder filling method has been developed by blowing a small amount of gas into the feed shoe. Next, unique warm compaction using die wall lubrication method, which was used water dispersions of lithium stearate, was developed. Net-shaping of commercial PM parts with high strength has been achieved by the application of the above methods.
収録刊行物
-
- 粉体および粉末冶金
-
粉体および粉末冶金 54 (7), 506-512, 2007
一般社団法人 粉体粉末冶金協会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390001206307256064
-
- NII論文ID
- 10019563010
-
- NII書誌ID
- AN00222724
-
- COI
- 1:CAS:528:DC%2BD2sXot12is7o%3D
-
- ISSN
- 18809014
- 05328799
-
- NDL書誌ID
- 8906194
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可