粉末圧延法による自己潤滑性焼結板の開発 I  黒鉛を含む銅‐ニッケル‐すず系の粉末圧延条件について

書誌事項

タイトル別名
  • The development of self-lubricating sintered plates by powder rolling method. (1).
  • フンマツ アツエンホウ ニ ヨル ジコ ジュンカツセイ ショウケツバン ノ カ
  • 黒鉛を含む銅―ニッケル―すず系の粉末圧延条件について

この論文をさがす

抄録

For the purpose to develope the self-lubricating sintered plates having high wear resistances for pressing machines and general industrial machines, powder rolling of premixed powders consists of Cu-28 wt%Ni-8 wt%Sn-5 wt%Fe-7 wt%(15P-Cu)-5 wt%C containing hydroxypropyl cellulose as an organic binder was performed using a mill with a working roll diameter of 600 mm. Thicknesses and apparent densities of rollcompacted sheets were measured, and the tensile strength of sintered sheets was investigated.<BR>Results obtained are as follows:<BR>(1) Keeping a constant depth (55 mm) of feed powder in hopper, the rolling load depends on the roll gap at the conditions of roll speeds from 0.3 to 0.7 m/min and the apparent density of green sheet increases gradually from 5.5 to 6.6 g/cm3 as the rolling load rises.<BR>(2) The tensile strength of roll-compacted sheets produced at roll speed 0.3 m/min, roll gap -0.2, 0 and +0.3 mm respectively depends on the sintering temperature, and the sheet after sintering for 40 min at 1250 K showed the tensile strength of maximum 160 MPa.

収録刊行物

被引用文献 (1)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ