書誌事項
- タイトル別名
-
- Characteristic of Ti-2at%Fe-10at%Si Powder Synthesized by Mechanical Alloying.
- メカニカルアロイング ゴウセイ シタ Ti 2atパーセントFe 10atパーセントSi フンマツ ノ トクセイ
この論文をさがす
説明
Ti-2at%Fe-lOat%Si alloy powder was synthesized by a mechanical alloying (MA) using a planetary ball milling as start materials of Ti powder, Fe powder and Si powder. The powders obtained by milling for more than 1440 ks were amorphous state. The recovery percentage of mechanically alloyed powder increased with the milling time. However, the composition and the crystallization temperature of the MA powder were almost unchanged even by varying the milling time. In the case of mechanical alloying for Ti-2at%Fe-1Oat%Si, amorphous powder is produced gradually after adhesion of the MA powder to the MA vessel and MA balls.<BR>The coarse particles of about 2 mm diameter were prepared by the adhesion of amorphous powders during the MA. These coarse particles were formed by filling up the gap between the MA balls of 10mm diameter with amorphous powders. The formation of coarse particles during the MA was able to be prevented by coexistence of the ball with a different size.
収録刊行物
-
- 粉体および粉末冶金
-
粉体および粉末冶金 50 (3), 205-209, 2003
一般社団法人 粉体粉末冶金協会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001206308921216
-
- NII論文ID
- 130000818580
-
- NII書誌ID
- AN00222724
-
- COI
- 1:CAS:528:DC%2BD3sXjtlWitbY%3D
-
- ISSN
- 18809014
- 05328799
- http://id.crossref.org/issn/05328799
-
- NDL書誌ID
- 6526760
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDLサーチ
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可
