Cutting conditions and residual stress distribution in orthogonal cut surface of aluminum
-
- ZAIMA Shigeo
- Faculty of Engineering, Shizuoka University
-
- YONETANI Shigeru
- Faculty of Engineering, Kanazawa University
-
- OKADA Takashi
- Graduate School of Shizuoka University
Bibliographic Information
- Other Title
-
- アルミニウム切削面における残留応力分布と切削条件について
- アルミニウム セッサクメン ニ オケル ザンリュウ オウリョク ブンプ ト セ
Search this article
Abstract
Orthogonal cutting tests of aluminum plates were carried out in such manners as repeated dry cutting, wet cutting, repeated wet cutting and combinations of them under different depths of cut, cutting speeds and rake angles to minimumize the residual stress. In the repeated cutting, the distribution of residual stress in the finally cut surface is considerably influenced by such a cutting condition that leads to high cutting resistance. Both wet and dry cutting result in the same patterns of stress distribution. A combination of dry rough cutting and wet finishing under the adequate cutting conditions ensures the cut surface free from residual stress.
Journal
-
- Journal of Japan Institute of Light Metals
-
Journal of Japan Institute of Light Metals 31 (8), 545-552, 1981
The Japan Institute of Light Metals
- Tweet
Details 詳細情報について
-
- CRID
- 1390001206336084608
-
- NII Article ID
- 130004208238
-
- NII Book ID
- AN00069773
-
- ISSN
- 18808018
- 04515994
-
- NDL BIB ID
- 2322844
-
- Text Lang
- ja
-
- Data Source
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- Abstract License Flag
- Disallowed