書誌事項
- タイトル別名
-
- Possibility of thickening of 1050 aluminum sheet by an incremental flatting process
- インクリメンタル ヘイタンカ プロセス ニ ヨル 1050 アルミニウム ウスイタ ノ ゾウニクカ ノ カノウセイ
この論文をさがす
抄録
Conventionally, sheet metal wastes with bend corners, such as automotive body panels and electric household appliance cases have been recycled through the smelting process. The smelting process has a recycling problem in which a large amount of CO2 emissions arises. To overcome this problem, without the smelting process, sheet metal wastes with bend corners are required to be unbent to flat sheet. Although these sheet metal wastes can be unbent to flat sheets, the thickness of the unbent sheet decreases along the bend line. Here, we propose an incremental flatting process in which the bent sheet can be thickened with flatting. For the purpose of clarifying adequacy of this proposed method, thickening behavior of 1050 aluminum sheets during the flatting was experimentally investigated. Experimental results suggested that bent sheets were flatted and, simultaneously, sheets thickness were increased. Farther, it was found that the thickening phenomenon was affected by blank holding conditions.
収録刊行物
-
- 軽金属
-
軽金属 57 (6), 234-239, 2007
一般社団法人 軽金属学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001206339423872
-
- NII論文ID
- 10019742190
-
- NII書誌ID
- AN00069773
-
- ISSN
- 18808018
- 04515994
-
- NDL書誌ID
- 8879615
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可
