アルミニウムと他の金属との切削温度の比較

書誌事項

タイトル別名
  • Cutting temperature of aluminum and other metals
  • Studies on cutting temperature of aluminum alloys (1st Report)
  • アルミニウム合金の切削温度について (第1報)

この論文をさがす

説明

For the purpose of investigating variation in cutting temperature between workpiece and tool during approximately orthogonal cutting, following experiments were conducted by tool-workpiece thermocouple method using cutting dynamometer for measuring cutting temperature and cutting force, simultaneously.<br>Cutting tests were carried out on 4 sorts of pure metals; i.e., aluminum (99.5% purity), copper (99.6%), magnesium (99.9%), and 0.25% carbon steel.<br>The following results were obtained.<br>(1) The measured values of cutting temperature in the above metals were arranged in ascending order as follows.<br>Mg_??_Al<Cu<Fe<br>(2) It was observed that cutting temperature rase with the increase of cutting speed or feed, but scarcely affected by depth of cut.<br>(3) Cutting temperatures of the above metals were proportional to their respective shearing stresses.<br>(4) The rising rates of cutting temperature in the above metals with respect to the increase of cutting speed or feed were arranged in descending order as follows.<br>With respect to cutting speed Mg>Cu>Al_??_Fe<br>With respect to feed Mg>Cu>Fe>Al

収録刊行物

  • 軽金属

    軽金属 18 (1), 2-12, 1968

    一般社団法人 軽金属学会

被引用文献 (2)*注記

もっと見る

詳細情報 詳細情報について

  • CRID
    1390001206341109120
  • NII論文ID
    130004207013
    10003903429
  • DOI
    10.2464/jilm.18.2
  • ISSN
    18808018
    04515994
  • データソース種別
    • JaLC
    • Crossref
    • CiNii Articles
  • 抄録ライセンスフラグ
    使用不可

問題の指摘

ページトップへ