五軸NURBS補間加工用CAMシステムの開発 : 一般化ポストプロセッサによるNCデータの生成(機械要素,潤滑,工作,生産管理など)
書誌事項
- タイトル別名
-
- Development of CAM System for 5-Axis NURBS Interpolated Machining : NC Data Generation by Generalized Post-Processor(Machine Elements and Manufacturing)
- 五軸NURBS補間加工用CAMシステムの開発--一般化ポストプロセッサによるNCデータの生成
- 5ジク NURBS ホカン カコウヨウ CAM システム ノ カイハツ イッパンカ ポストプロセッサ ニ ヨル NC データ ノ セイセイ
この論文をさがす
抄録
NURBS (Non-Uniform Rational B-Spline) is well known to express free-form curves and surfaces in current CAD systems. Some NC controllers can accept NC data written in the NURBS interpolated format by using G 06.2 code, and NURBS interpolated machining enables us to decrease the amount of NC data, to eliminate the error due to the linear interpolation and so on. Although there are a few post-processors to generate NURBS interpolated NC data for simultaneous 5-axis controlled machining, most of them transform linear interpolated NC data into NURBS interpolated ones by the least square method and so on. Therefore, if the linear. interpolated NC data is huge, the conventional post-processor may require a long calculation time to generate NURBS interpolated ones. In addition, the post-processor lacks general versatility because it copes with a specific machining center. To solve these problems, the study deals with developing a generalized post-processor which can generate NC data without the linear approximation, while considering the axis composition of various machining centers. As the result, it is found that the developed post-processor efficiently generates practical 5-axis NURBS interpolated NC data.
収録刊行物
-
- 日本機械学会論文集Ｃ編
-
日本機械学会論文集Ｃ編 75 (749), 216-222, 2009
一般社団法人 日本機械学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001206386062080
-
- NII論文ID
- 110007045476
-
- NII書誌ID
- AN00187463
-
- ISSN
- 18848354
- 03875024
-
- NDL書誌ID
- 9802279
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可