２９Ｃｒ‐４Ｍｏ‐２Ｎｉフェライト系ステンレス鋼の耐孔食性に及ぼす熱処理条件の影響

DOI Web Site 被引用文献1件

書誌事項

タイトル別名
  • Effect of Heat Treatment on the Pitting Corrosion Resistance of 29Cr-4Mo-2Ni Ferritic Stainless Steel
  • 29Cr 4Mo 2Ni フェライトケイ ステンレス コウ ノ タイ コウショ

この論文をさがす

抄録

The effect of heat treatment on the pitting corrosion resistance of 29Cr-4Mo-2Ni ferritic stainless steel was investigated. The results as follows.<br>(1) The optimum heat treatment of 29Cr-4Mo-2Ni steel is heating at 1000°C and water quenching. In case of addition of Nb and Ti, it is heating at 1100°C and water quenching.<br>(2) In high chrominum ferritic stainless steel, carbon and nitrogen are normally controlled less than 300ppm in the total, but in this investigation a favourable pitting corrosion resistance can be obtained by heating at 1000°C and water quenching even if it contains such a high amount as 770ppm.<br>(3) In case of heating at temperature over 1100°C, there occurs sensitization by the grain boundary precipitation of Cr23C6 and Cr2N and accordingly, the pitting corrosion resistance gets deteriorated.<br>(4) In case of heating up to 800-900°C there occurs precipitation of σ phase and due to lack of Cr and Mo in α phase the pitting corrosion resistance gets deteriorated. The degree of deterioration is not influenced by the amount of carbon and nitrogen, but there is a tendency that it gets rather big by the addition of Nb or Ti.

収録刊行物

  • 電気製鋼

    電気製鋼 50 (4), 272-279, 1979

    大同特殊鋼株式会社

被引用文献 (1)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ