-
- 田辺 郁男
- 長岡技術科学大学機械系
-
- 井山 徹郎
- 長岡技術科学大学機械系
-
- Moe Aung Lwin
- 長岡技術科学大学工学部
-
- 近藤 龍一
- 長岡技術科学大学工学部
書誌事項
- タイトル別名
-
- High Speed Polishing for Large Die and Mold(Machine Elements, Design and Manufacturing)
- 大型金型の高速ポリシング加工
- オオガタ カナガタ ノ コウソク ポリシング カコウ
この論文をさがす
抄録
Recently, mirror-like surface is required for adding high quality on the most products. Polishing process is almost used for machining the mirror-like surface. However, when many workers make a large die and mold with the mirror-like surface in many machine shops, it is necessary for them to polish very long time. Therefore, in this paper, high speed polishing for large die or mild was developed and evaluated. The polishing system for large die and mold consists of the NC milling machine and the polishing tool using the several polishing units. And the polishing unit consists of polishing head, spring, shaft and linear guide. The polishing unit with no-chatter was firstly developed, and the optimum polishing condition for the unit was investigated in several experiments. The polishing tool was developed for a large die and mold by using the several polishing units. This system was evaluated for high speed polishing on the flat and curve surfaces of the large die. It is concluded from the results that (1) Mirror-like of large die and mold surface were machined by this polishing system, (2) The polishing time using this polishing system is one over three hundred than that of the conventional polishing.
収録刊行物
-
- 日本機械学会論文集C編
-
日本機械学会論文集C編 76 (772), 3822-3827, 2010
一般社団法人 日本機械学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001206387792640
-
- NII論文ID
- 110008006900
-
- NII書誌ID
- AN00187463
-
- ISSN
- 18848354
- 03875024
-
- NDL書誌ID
- 10955173
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可