書誌事項
- タイトル別名
-
- The Tensioning for a Tipped Saw Using the Temperature Distribution on Its Base Metal(Mechanical Systems)
- 台金の温度分布を利用した丸鋸の腰入れ
- ダイキン ノ オンド ブンプ オ リヨウシタ マルノコ ノ コシイレ
この論文をさがす
説明
In this paper, we considered a new tensioning method by the temperature distribution on the base metal of tipped saw. First, the relationship of the temperature distribution on the base metal and the tensioning effect (i.e. transitions of natural frequency) was examined by calculation using a disk model. As the results, when the temperature Θ_c at inner circumference of the disk was higher than the temperature Θ_a at outer circumference, the natural frequency of the two or higher nodal diameters mode increased. And the increments of the natural frequencies were proportional to the temperature deference Θ_c-Θ_a. Furthermore, the tangential residual stress σ_θ at outer of disk had positive value denoted as tensile stress. These results coincided with the effects of the traditional tensioning method so called 'Roll Tensioning'. Then, the validity of the calculation results by experiment using disk was verified. The transition of the natural frequency by the experiments indicated similar tendency to the calculation results.
収録刊行物
-
- 日本機械学会論文集Ｃ編
-
日本機械学会論文集Ｃ編 76 (772), 3330-3335, 2010
一般社団法人 日本機械学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390001206388249856
-
- NII論文ID
- 110008006839
-
- NII書誌ID
- AN00187463
-
- ISSN
- 18848354
- 03875024
- http://id.crossref.org/issn/03875024
-
- NDL書誌ID
- 10939065
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDLサーチ
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可