書誌事項
- タイトル別名
-
- Error Estimation to Linear Interpolation Cutter Path of Machining Center due to Acceleration/Deceleration Motions between Two Interpolation Segments(Machine Elements, Design and Manufacturing)
- セグメント間の加減速運動に起因するマシニングセンタの直線補間工具経路の誤差推定
- セグメント カン ノ カゲンソク ウンドウ ニ キイン スル マシニングセンタ ノ チョクセン ホカン コウグ ケイロ ノ ゴサ スイテイ
この論文をさがす
抄録
This paper proposes a practical approach to estimating the path errors produced by the NC acceleration/deceleration motions around connection points between every two segments for a linear interpolation cutter path of a machining center. The approach consists of two parts. The first is an experimental method to identify the value of each related parameter in NC appareture to the acceleration/deceleration motion control, in which only an operation is needed to measure a few simple motion trajectories with two linear segments with the machining center. The other part is a concise and efficient simulation algorithm based on the identification results for a cutter path composed of a number of short linear segments. A comparison result of the simulated cutter path trajectories with the measured ones and contours of machined work pieces sufficiently demonstrates the effectiveness and reliability of the proposed approach. Therefore, as a useful tool, the approach is applicable to beforehand estimating the influence of the NC acceleration/deceleration motions on cutter path accuracy or judging the cutting conditions for the machining purpose without performing an actual machining test with the machining center.
収録刊行物
-
- 日本機械学会論文集C編
-
日本機械学会論文集C編 76 (770), 2719-2728, 2010
一般社団法人 日本機械学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390001206388612736
-
- NII論文ID
- 110007817393
-
- NII書誌ID
- AN00187463
-
- ISSN
- 18848354
- 03875024
-
- NDL書誌ID
- 10884737
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可