-
- Tsujimoto Tokuzou
- Non-Ferrous Metal Division, National Research Institute for Metals
-
- Sasano Hisaoki
- Non-Ferrous Metal Division, National Research Institute for Metals
-
- Adachi Masao
- Department of Physical Metallurgy, Faculty of Engineering, Kyoto University
Bibliographic Information
- Other Title
-
- Ti-8%Al-4%Co合金の高温機械的性質について
- Ti-8パーセント Al-4パーセント Co ゴウキン ノ コウオン キカイテキ セイシツ ニ ツイテ
Search this article
Abstract
Ti-8%Al-4%Co alloy can be expected to have good mechanical properties at high temperatures because of its high aluminium content. At first, the effect of heat treatment on the creep-rupture properties was investigated. From the results, the heat treatment, i.e., quenching from 700°C, was selected for high temperature use. Then tensile, creep-rupture and fatigue properties at high temperatures were investigated.<BR>The results are as follows:<BR>(1) Up to 500°C in testing temperature, the tensile strength at elevated temperature is slightly affected by testing temperature, and over 500°C it decreases markedly. The tensile strength at 500°C is 82.5 kg/mm2.<BR>(2) Above 460°C the crrep-rupture strength is lower than the fatigue strength and below this temperature the latter is lower. The creep-rupture strength for 1000 hr is 32 kg/mm2 at 500°C and decreases linearly between 400°C and 600°C. The fatigue strength for 107 cycles is 47.4 kg/mm2 at 400°C and hardly varies below 400°C.
Journal
-
- Journal of the Japan Institute of Metals and Materials
-
Journal of the Japan Institute of Metals and Materials 31 (3), 223-227, 1967
The Japan Institute of Metals and Materials
- Tweet
Details 詳細情報について
-
- CRID
- 1390001206481708800
-
- NII Article ID
- 130007333334
- 40018256147
-
- NII Book ID
- AN00187860
-
- ISSN
- 18806880
- 24337501
- 00214876
-
- NDL BIB ID
- 8371461
-
- Data Source
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- Abstract License Flag
- Disallowed