-
- 城戸 太司
- Depertment of Design, Faculty of Engineering, Chiba Institute of Technology
-
- 蓜島 淳史
- Master's Program in Mechanical Engineering and Science, Graduate School of Engineering, Chiba Institute of Technology
-
- 茂木 徹一
- Department of Mechanical Engineering and Science, Faculty of Engineering, Chiba Institute of Technology
書誌事項
- タイトル別名
-
- Plastic Working Characteristics of AZ31B Magnesium Alloy Sheet Produced by Continuous Casting Using Semisolid Slurry
- AZ31Bマグネシウム ゴウキン セミソリッドスラリー オ モチイテ レンゾク チュウゾウ シタ ハクバン ノ カコウ トクセイ
この論文をさがす
抄録
We produced AZ31B magnesium alloy sheet by our semisolid casting method to cast slurry produced using an inclined cooling plate into the twin-roll. In this paper, the sheet obtained by this process was examined for texture, roll workability and Erichsen value compared with the chill cast plate and commercial AZ31B sheet. The results are as follows. The microstructure of continuously cast sheet exhibits fine grains of primary Mg-crystals. A (0001) pole figure of the continuously cast sheet confirms that the crystal direction was random and there was little rolling anisotropy. Influence of different heating temperatures on accumulative rolling reduction of the twin-roll cast sheet was not appeared by different roll directions versus the casting direction. The accumulative rolling reduction of the twin-roll cast sheet is higher than chill cast sheet in case of heating temperature of 473 K or less. The Erichsen test indicated excellent value.<br>
収録刊行物
-
- 日本金属学会誌
-
日本金属学会誌 77 (5), 165-169, 2013
公益社団法人 日本金属学会
- Tweet
詳細情報 詳細情報について
-
- CRID
- 1390001206482580608
-
- NII論文ID
- 10031168438
-
- NII書誌ID
- AN00187860
-
- COI
- 1:CAS:528:DC%2BC3sXpvV2gtL4%3D
-
- ISSN
- 18806880
- 24337501
- 00214876
-
- NDL書誌ID
- 024654899
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可