3D Fracture Behaviours in Dual-phase Stainless Steel

DOI 機関リポジトリ (HANDLE) Web Site 被引用文献7件 参考文献28件 オープンアクセス
  • Toda Hiroyuki
    Department of Mechanical Engineering, 3D/4D Structural Materials Research Centre, Kyushu University
  • Tomizato Fukuto
    Department of Mechanical Engineering, Toyohashi University of Technology
  • Harasaki Ryo
    Department of Mechanical Engineering, Toyohashi University of Technology
  • Seo Dowon
    Department of Mechanical Engineering, 3D/4D Structural Materials Research Centre, Kyushu University
  • Kobayashi Masakazu
    Department of Mechanical Engineering, Toyohashi University of Technology
  • Takeuchi Akihisa
    Japan Synchrotron Radiation Research Institute
  • Uesugi Kentaro
    Japan Synchrotron Radiation Research Institute

書誌事項

公開日
2016
資源種別
journal article
DOI
  • 10.2355/isijinternational.isijint-2015-631
公開者
一般社団法人 日本鉄鋼協会

この論文をさがす

説明

Single-distance phase retrieval technique was applied to contrast-enhanced phase-sensitive imaging of dual-phase microstructures in ferrite/austenite dual-phase stainless steel. Contrast between the two phases was evaluated, together with noise and spatial resolution, under varying experimental and phase retrieval conditions. Serial sectioning technique was also employed, to validate the shape accuracy of related three-dimensional images. Although the density difference between the two phases was relatively small, the two phases were successfully segmented in the three-dimensional images. The imaging technique was also applied to observe microvoid nucleation and growth behaviour during tensile loading. The loading steps at which microvoids were nucleated were identified by tracking all the microvoids observed at the final loading step, in reverse chronological order, toward the initial unloaded state. Each absorption-contrast image was then registered with a corresponding phase-contrast image, in order to classify all the targeted microvoids according to their nucleation site: ferrite, austenite or phase boundary. Premature damage initiation was observed at a relatively early stage at all the nucleation sites; however, subsequent growth was relatively moderate. On the other hand, microvoids initiated later, at fine particles located along the phase boundaries, exhibited enormous growth, thereby inducing the final rupture. It was concluded that the substantial driving force for the growth of microvoids located along morphologically characteristic austenitic particles was the predominant factor in the ductile fracture.

収録刊行物

被引用文献 (7)*注記

もっと見る

参考文献 (28)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ