Quantitative Analysis of an Antioxidant Additive in Insoluble Plastics by Surface-Assisted Laser Desorption/Ionization Mass Spectrometry (SALDI-MS) Using TiO2 Nanoparticles

DOI 機関リポジトリ HANDLE Web Site Web Site 被引用文献1件 参考文献50件
  • OSAKA Issey
    Center for Nano Materials and Technology, Japan Advanced Institute of Science and Technology
  • OKUMURA Koji
    Faculty of Chemistry, Materials and Bioengineering, Kansai University
  • MIYAKE Naoki
    Faculty of Chemistry, Materials and Bioengineering, Kansai University
  • WATANABE Takehiro
    Faculty of Chemistry, Materials and Bioengineering, Kansai University
  • NOZAKI Kazuyoshi
    Faculty of Chemistry, Materials and Bioengineering, Kansai University
  • KAWASAKI Hideya
    Faculty of Chemistry, Materials and Bioengineering, Kansai University
  • ARAKAWA Ryuichi
    Faculty of Chemistry, Materials and Bioengineering, Kansai University

この論文をさがす

抄録

The applicability of matrix-free surface-assisted laser desorption/ionization mass spectrometry using porous silicon (DIOS-MS) and TiO2 nanoparticles (TiO2-SALDI-MS) was examined by analyzing an antioxidant added to insoluble polypropylene (PP) materials. The optimized solvent extraction, which involved freezing and crushing the PP, results in a good recovery, 89±4 and 97±8% for 0.5 wt% of the added antioxidant, tetrakis[methylene3-(3,5-di-t-butyl-4-hydroxyphenyl)propionate]methane (commercial name; Irganox1010) in laboratory-produced and commercial PP composites, respectively. The positive ion measurements in DIOS and TiO2-SALDI-MS yielded sodium adduct ions without any interference from other signals. Using an internal standard with a similar structure, a good calibration curve linearity was established in the Irganox1010 concentration range of 0.01-2.0 mg/mL in PP, which was sufficient for monitoring the plastic additives. However, TiO2-SALDI-MS was superior to DIOS-MS in terms of mass resolution and easiness of sample preparation. A solvent extraction method followed by TiO2-SALDI-MS appears to be a anticipated method for the analysis of additives in insoluble plastics.

収録刊行物

  • 質量分析

    質量分析 58 (4), 123-127, 2010

    一般社団法人 日本質量分析学会

被引用文献 (1)*注記

もっと見る

参考文献 (50)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ