書誌事項
- タイトル別名
-
- Deep Drawing with Ultrasonic Vibration
- チョウオンパ オ フカ シタ フカシボリ カコウ
この論文をさがす
抄録
<tt>In this paper, we described deep drawing that entailed ultrasonic vibration. The deep drawing method described uses with a punch, a die and a tool of blank holder. In this study, a metal mold through which a die exhibited longitudinal vibration was produced experimentally. A bolt-clamped Langevin-type transducer vibrator was used as the source of vibration. Using this manufactured metal mold, the decrease in the largest deep-drawing load and the improvement in the limiting drawing ratio were compared and examined with usual restrictions. It was also used for general purposes and restrictions and for deep-drawing cold-rolled steel sheets as processed materials. The result showed that the maximum load decreased, but no improvement in the limiting drawing ratio could be observed</tt><tt>. </tt>
収録刊行物
-
- 塑性と加工
-
塑性と加工 54 (624), 47-51, 2013
一般社団法人 日本塑性加工学会
- Tweet
キーワード
詳細情報 詳細情報について
-
- CRID
- 1390001206498159104
-
- NII論文ID
- 10031139506
-
- NII書誌ID
- AN00135062
-
- COI
- 1:CAS:528:DC%2BC3sXms1Wqsro%3D
-
- ISSN
- 18820166
- 00381586
-
- NDL書誌ID
- 024242277
-
- 本文言語コード
- ja
-
- データソース種別
-
- JaLC
- NDL
- Crossref
- CiNii Articles
-
- 抄録ライセンスフラグ
- 使用不可