押出し角管の回転引曲げ加工における<br>軸引張り負荷の効果

書誌事項

タイトル別名
  • Effects of Applying Axial Tension in the Rotary Draw-Bending<br>Process of Extruded Square Tubes
  • オシダシ カクカン ノ カイテン ヒキマゲ カコウ ニ オケル ジク ヒッパリ フカ ノ コウカ

この論文をさがす

抄録

The use of extruded aluminum alloy sections is advantageous for reducing the weight of many types of structure. In general, a secondary forming process such as bending is required when these materials are applied on structural members. However, in the bending process, undesirable deformation such as flattening and wrinkling arise easily. In this study, an improved rotary bending process is used for fabricating light gauge square tubes of A6061S and 63S-O. Flattening distortion on the cross section is restrained using an elastic laminated mandrel. In this study, we show that applying optimum axial tension is effective for suppressing wrinkling in order to reduce compression strain. For example, bend degree reaches 4.3 at the minimum R0/H0 without any defects, under the working conditions using a thickness ratio of A6061S and 63S-O tubes of t0/H0=0.038, where R0, H0 and t0 are the radius of the central plane, and the height and thickness of the square tube, respectively. Moreover, applying axial tension is effective for increasing the working limit, especially for thin-walled tubes, because in the thickness ratio of A6063S-O of t0/H0=0.025 the working limit is 10.3-fold that under non axial tension.

収録刊行物

  • 塑性と加工

    塑性と加工 52 (604), 574-578, 2011

    一般社団法人 日本塑性加工学会

被引用文献 (5)*注記

もっと見る

参考文献 (11)*注記

もっと見る

詳細情報 詳細情報について

問題の指摘

ページトップへ