鋼管の冷間減径加工時の余剰変形とその抑制技術

DOI Web Site Web Site 被引用文献3件 参考文献5件

書誌事項

タイトル別名
  • Suppression of Excess Deformation on Top Portion of Steel Tube after Cold-Reducing through Die
  • コウカン ノ レイカン ゲンケイ カコウジ ノ ヨジョウ ヘンケイ ト ソノ ヨクセイ ギジュツ

この論文をさがす

説明

Deformation of a steel tube was investigated when its outside diameter was cold-reduced through a die. Numerical analyses by axi-symmetric elastic-plastic finite element analysis (FEA) were carried out. When a conventional die with a single die angle was used, the outside diameter of the top portion of the tube became slightly larger, and the wall thickness became thinner than the middle portion. The influences of the wall thickness of the tube and the die angle were investigated. To check the validity of the result, an experiment was carried out. Then, numerical investigation by FEA was carried out to determine the optimum geometry of a die that would decrease the degree suppress this phenomenon followed by an experiment to check validity. The optimum die geometry happened to have the same geometry as that proposed by the authors for suppressing the undershooting phenomenon and the bending phenomenon. It is able to decrease the different level of deformation between the top and the main portion of the tube.

収録刊行物

  • 塑性と加工

    塑性と加工 47 (544), 368-372, 2006

    一般社団法人 日本塑性加工学会

被引用文献 (3)*注記

もっと見る

参考文献 (5)*注記

もっと見る

キーワード

詳細情報 詳細情報について

問題の指摘

ページトップへ